This floor mat set was definitely cut "to shape" the interior of my 2017 Tacoma, but unfortunately just misses the mark in execution. Specifically, as seen in my photos, the driver's side folds inward and creates a 2" gap down the length of the side against the transmission tunnel, and the passenger side overlapping the door sits high/above the door trim. I had to use a bunch of safety pins unfolded to try and tack the doormat against the carpet to hopefully encourage it to fit correctly... but after a week of that, it helped only in the slightest. The passenger front I'm less concerned about it collecting dirt underneath and more concerned of it being a tripping hazard for my passengers. The rear has no excuse, it just doesn't fit correctly. The pictures I attached show that it sits high because of the front seats' mounting hardware. The material feels ok, and maybe in the summer when the temperatures are substantially warmer, it will make the material soft and conform properly to the intended shape, but that's months away and I'm currently in winter where I need it most to keep the snow and salt off my carpet. NOTE: the only reason this is "not for 2016-17" is because the passenger side in these 2 model years lack the anchor points on the floor to lock the mat in place. The anchors exist on the driver side and work as intended. Even though it lacks on the passenger side, its still the exact same shape; it's all third gen Taco after all.